A water-based sealer that resists water, oil, and acid-based contaminants. Simplifies maintenance and does not change the appearance of the grout. Allows moisture vapor transmission.
USE CHEMICAL-RESISTANT GLOVES, such as nitrile, when handling product. Read entire label before using.
Surface should be dry, clean and free of waxes, sealers or finishes. New installations need to dry 48 hours before application. Protect surrounding surfaces. Test product in an inconspicuous area to ensure desirable results.
Apply by spraying or using a softbristle paintbrush or sponge paint applicator. NOTE: Be sure to wipe surface completely dry within 5 minutes of each application using absorbent paper, cotton or microfiber towels. After 2 hours conduct a test to determine if surface is completely sealed by applying water droplets to the surface. If water is absorbed, apply an additional application. Wait 2 hours and repeat the test. May be reapplied as needed to grout joints that are clean.
Suitable Tile Types
Recommended for cement-based sanded and unsanded grout joints for ceramic, porcelain and glass tile installations. For interior and exterior use.
Limitations to the Product
- Do not allow sealer to come in contact with any non-recommended surface.
- If product is allowed to dry on surface, a white film may form. If this occurs, scrub with Aqua Mix NanoScrub and a white nylon pad.
- Sealer will not prevent surface wear or etching from acids or caustic chemicals.
Approximately 75 to 225 sq. ft.